Contenu récent par Alhambra82

  1. A

    [TUTO] Télécodage et calibration d'un NAC / RCC / CIROCCO / CMB_NUM SANS Diagbox via Arduino

    @VLud that was a good job! Congratulations and thanks for the info. I have an issue related to the rear camera in the Proace: when a caravan is attached, the rear camera will not show if we use the rear gear. Fair enough... but it will not show either, even if a bicycle transport is attached...
  2. A

    [TUTO] Télécodage et calibration d'un NAC / RCC / CIROCCO / CMB_NUM SANS Diagbox via Arduino

    Hello everyone! Does anyone have the .cal file for a Proace NAC Wave3? The one in the repro is for Wave2 :(
  3. A

    [TUTO] Télécodage et calibration d'un NAC / RCC / CIROCCO / CMB_NUM SANS Diagbox via Arduino

    Do you get any message on the car's display when connecting your Android phone?
  4. A

    [TUTO] Télécodage et calibration d'un NAC / RCC / CIROCCO / CMB_NUM SANS Diagbox via Arduino

    Yes but it does not appear in any menu on the display.
  5. A

    [TUTO] Télécodage et calibration d'un NAC / RCC / CIROCCO / CMB_NUM SANS Diagbox via Arduino

    I am kind of stuck here... I need some help on my father´s Toyota Proace Verso. I already asked @e21fian but unfortunately he could not help me. I want to activate his DAB Radio and the inside lights on the ceiling over the back seats. Both are physically installed but do not work/there is no...
  6. A

    [TUTO] Télécodage et calibration d'un NAC / RCC / CIROCCO / CMB_NUM SANS Diagbox via Arduino

    Oh no, I do respect this fully! I just wanted to know if I can connect and change things as many times as I want on my own car :)
  7. A

    [TUTO] Télécodage et calibration d'un NAC / RCC / CIROCCO / CMB_NUM SANS Diagbox via Arduino

    Well, I have experimented a little bit on my own car and I must say, that I am really impressed! However, there is something that is annoying me since yesterday: the outside temperature (up left corner on the display) will not appear. When I use my parameters back up and go back to "normal", it...
  8. A

    [TUTO] Télécodage et calibration d'un NAC / RCC / CIROCCO / CMB_NUM SANS Diagbox via Arduino

    But, are you running a WAVE3/4 on your 208? :)
  9. A

    [TUTO] Télécodage et calibration d'un NAC / RCC / CIROCCO / CMB_NUM SANS Diagbox via Arduino

    Hi everyone! Just registered in this forum although I have been following it for a longer time :). Today I ordered the necessary hardware for the connection (I decided to buy shield 2.0) and I am really excited about how much "juice" I can get out of my NAC headunit. It will probably will take a...