Contenu récent par Andrew_PL

Do you have such seats in your car? If your seats don't have this option, activating it alone won't change anything. The same goes for massage. In addition, changes are also needed in VSM.

Since it wasn't there at the factory, for some reason it's not possible. The same goes for the MANUAL option.

First, you have the wrong shift lever for manual mode. This is probably why it doesn't work because your shift lever doesn't have the appropriate CAN command programmed into it.

But this isn't just about IVI, as I also have invisible and erroneous zones in VSM1. It's hard to describe everything.

Unfortunately, Alicar ACT v2 isn't fully usable. It might be good for IVI MID( i don't try it), but for IVI High it has many bugs and omissions. On my IVI HIGH, a setting might be active but it reads as inactive. Some functions are incorrectly assigned, and some aren't displayed at all. This is...

This "club" is closed to us. Not at this level of advancement.

Because the problem may be the gearbox software and without changing it it is not possible to connect the e-toggle.

Look here https://www.forum-peugeot.com/Forum/threads/tuto-t%C3%A9l%C3%A9codage-et-calibration-dun-nac-rcc-cirocco-cmb_num-sans-diagbox-via-arduino.121767/post-2695481

I finally managed to obtain the data using Alicar ACTv2. However, it wasn't sufficient and had errors in determining position NV within the zones (wrong position of NV Push Button). Therefore, what I'm providing below won't work in every IVI. Required changes to enable NightVision in the DS4...

I tried it and it's ok but.. in IVI turns on NV, doesn't turn on NV touch button so I can't use NV. In the speedometer and VSM1 the NV option is active. If anyone has a backup config from DS4 IVI with NV, Vision360 cameras and a dead zone I would be grateful. You can make a backup with the...

Zones in IVI Has anyone read it and knows the functions that correspond to them? I'm especially looking for info on NightVision, V360 cameras, dead zone alarm I don't intend to change IVI, just modify the one I have in the car.

but in gray which means they don't work because they should be red since that's the main color

In this NAC options you need are in grey - thats mean no way for this on screen. He only said it worked but didn't show it. In NAC setup he chose P507 - this is first step in NAC cofiguration in P407

By Diagbox you can check it.

For 99% there is no option to activate these functions for your car (p407). Only available functions such as radio, navi, android/carplay and... check. You will not set the air conditioning and other functions of your car available from the factory on the old radio.