Contenu récent par CarambaMSK

problem solved! had to connect arduino to NAC directly (without BSI). Merci beaucoup à tous pour votre aide

yes, NAC is working, Multi-touch is working.

Thank you for your patience. I have tried 2 displays, 3 diagbox versions, 2 BSI, no luck so far, should i try to change NAC calibration? NAC software may be? Need your advice.

what BSI do you use on the bench: old type BSI2010 or new type BSI2010_EV ?

no, identification for touch screen does not work (no dialogue ), but if i do "actuator test - > touch screen test" in NAC options - diagbox says "press on the target detected "

on the bench

yes, in NAC config i set DGT8C, screen reference is hard to tell, sticker on it is missing. attached label picture on lcd i have another display 7inch, i configure it as DGT7C and tried to invert it - also did not work.

Bonjour, selon ce post, les commandes suivantes devraient inverser l'image affichée. J'ai la Wave2 + DGT8, j'ai essayé de taper le code: >764:664 (réponse "OK") 1003 (response 500300C80014) > 743:643 (réponse "OK") :16FB:03:03 (pas de réponse) 2E211082 (pas de réponse) rien ne se passe...