Contenu récent par caspiu

the map on the instrument panel appears with this new media.

Hello Felix could you inform how you accessed the NAC if you went through the UART port and the command used.

OK, thanks for the help

hello I wanted to know which pins are used to connect the RTC module in the arduino of the dual CAN to NAC? I didn't find the electrical schematic with it complete if you can help me with the information.

hello everyone, does anyone know what the option to disable video blocking in motion? I'm using a NAC WAVE 2 that plays video only with the car stopped, when moving the car the video blocks and just keeps playing the audio.

Hello everyone !! buy a NACEUR WAVE4.1 W4_B4HD_HW19 from a Peugeot 2008 1.5 HDI, I turned on a screen of 3008 DGT8 and there was no start image just flashed the screen, I used the program to configure the NAC resolution and did not accept the settings, the screen appears image so not complete...

Are you installing an arduino to control the cirocco panel menu? has the electrical scheme of this project to see where the error is?

To use the 3008 Cirocco panel on a 208 you don't need an arduino adapter to make it work, the BSI of the 208 and CAN2010 that works with the new panel. be careful when using these adapters in the dashboard, if the configurator is not well, you can change the vehicle's KM !!!

Yes, same ID and finder on CAN CAR 125KBs the values are fixed, as you press the scroll up, the value increases (a bit is added) and the same if you press the scroll down, it decreases one bit. you can make the arduino always send 00 when pressing the button this value changes to 01 and back...

Hello everyone !! after a few tests I managed to play the video on NAC and I found out that the video resolution is supported by 800x480 .

Hi, I did a test and it wasn't successful, the video keeps playing and only the audio comes out and black screen, the message "Unauthorized display" disappeared, I noticed that only a video file is played (.WMA) I believe it has more functions hidden in the NAC to play the video or some specific...

Hi !! Below is information to change the screens of the CIRROCO 3008 panel ID: 0A2 - DLC 06 - DATE: 00 00 00 01 00 00 as you change the bytes the menu also changes, it can be fixed as you press the button or variable as a scroll button "Scroll".

Hello everyone !! I have a problem, after updating the NAC map it stopped making available on the 3008 dashboard, the program shows that it is enabled for 2 LVDS functions, but the map does not appear on the panel. Has anyone been through this and can you help?