Contenu récent par Corin

Have you ever read the first page where are all the main details? I do not say reading all the pages of the topic that you will not do it. You could also use the Edit button if no one posts after you instead of doing 2-3 consecutive posts

Button for change mode work? I noticed that in BSI for Stalk left, there are 5 possibilities. Nothing, Diurnal Lights, Headlers, Citizen Warning, Telematic System. When it is a telematic system when pressing is the voice command and corresponds to "frame is 221 data[0]==0x01". At mine, Citizen...

Hello. I have been able to do the adapter to work in left or right stalk. I mounted the adapter before Circco It does not go from the button, Mode Change appears, but do nothing. I tried before NAC and works the same without a button I think it was not going before because I try to mount the...

Hi. Do you have an idea why show me the area is not mapped and does not display the estimated time until arrival on cirocco? On NAC are displayed. 3008 Cirocco and 2008 the car with 2008 cal

I press twice fast. I will try tomorrow again CAN INFO DIV <=> ARDUINO <=> CLUSTER

I have connected the adapter between BSI and NAC. The NAC operates and sends data to cirocco and the command from the Right Stalker end sends command to NAC and cirocco. But the adapter does not work. In the Arduino console, the commands appear, but do not change the cluster mode. When pressing...

How do you set left stalk? For trip and brightness i do the same.

Thank you for information @marcins . I'll try BSI->Adapter->NAC so I can see if I can change cluster mode in cirocco. At least one of the orders go, from the dedicated button or the button in the right stalk end

I don't want to use buttons for nac, just to check if adapter work with cirocco, if information traffic reaches cirocco. I'm trying to identify where the problem is because the adapter does not work at me. When I connect the adapter does not get information at cirocco and when i use the change...

Hmmm. i use jumper now, maybe this is the problem for traffic through adapter. I could try with the CAN Conversion Sketch 2004 to Can 2010 arduino-psa-comfort-can-adapter.ino from @VLud to see if BSI communicates with cirocco? Or just need to activate debug on your sketch to see trafic? I have...

I use only ground(GND) from arduino to can card and pin 7 with pin14(GND) for cluster change. And only arduino power from pc. Do i have to connect GND from arduino to car ground? The J1 from CAN card need to be open or sold together. In your video i see pin 8 and 9 from cluster connector the...

Yes, i want to change clusters in cirocco BSI-CAN0-Arduino-CAN1-Cirocco CAN0 -CS PIN to PIN 9 Arduino CAN1 -CS PIN to PIN 10 Arduino The rest of the connections are like in the picture For the Cirocco i use power pin 1, ground pin 8, low pin 7 and hi pin 9. From BSI -connector 60V BE pin 27 Hi...

I know sketch is good. But where is my error in connections? I believe that you normally without sketch this adapter should allow the information on both directions. For me the information does not pass or is in short. When connecting the adapter cirocco illuminates without contact with the key...

I will check again. But the first situation is the right Low and Hi if i know right from @VLud tuto here. For the Cirocco i use power pin 1, ground pin 8, low pin 7 and hi pin 9. Only 4 wire because the rest of wire does not have the rest of functions that connect on dash for 2008. 3008 Cirocco...

I need arduino to change mode on Cirocco. Else it work very well without arduino.