Contenu récent par Dário Araújo

What i as saying is that i tried many versions of diagbox and could never perform a single coding session, because my car is a 2017 Peugeot 3008. I even haven´t tried to code the e-toggle. Sorry if i miss interpretate myself. I´ve seen videos here this guy can choose several options for a...

Hello there, i have a question, i´m planing to replace the gear lever selector joystick from my 2017 Peugeot 3008 with the new e-toggle. I´ve already have 2 wires from the blue "D" connector off the bsi 2010ev, pins 23 and 25 for the e-toggle because i know that it uses the Can HS3 H and Can HS3...

Yes i know that, the thing is, nothing happens when i press the mem button, it´s almost like there is no "speeds" in "memory" to call when the MEM buttons is pressed.

Good evening. I believe I've found a potential solution to my cruise control issue where the system is not saving the detected speeds. Could you please give me some pointers in how to read the current values in this zones and how to change them to the correct values that would allow the cruise...

Good evening, I believe I've found a potential solution to my cruise control issue in this post. The problem is that the cruise control isn't saving the speeds detected by the CVM. Could someone please guide me on how to program an Arduino to make the cruise control adopt the speeds detected by...

Good evening dear friend, then can I upload the 3008_P84E-9694131380.cal file with the Arduino without any problems? Should i connect a charger to the battery in order to prevent from the car enter in eco mode an ruin the update? Thanks Merci @marcins

Alors, je vais essayer de charger le fichier 3008_P84E-9694131380.cal (Pourquoi pas le fichier 3008_P84E-9694834680.ulp ? Il est plus récent et le firmware de mon Cirocco est > sw20.0.) pour voir si cela résout le problème du régulateur de vitesse. Mais si cela prend 4 heures, je le ferai...

D'accord, je dois donc charger le fichier .ulp. Lequel dois-je choisir ? Okay, so I should load the .ulp file. Which one should I choose? 3008_P84E-9693388280.ulp . Apr 27, 2023 3008_P84E-9694131380.cal . Apr 27, 2023 3008_P84E-9694131380.ulp . Apr 27, 2023...

Bonjour, Je me demande si le fichier de calibration .cal est manquant sur mon tableau de bord (Cirocco). J'ai acheté un nouveau Cirocco et le vendeur m'a dit qu'il fallait d'abord le configurer pour que toutes les fonctions de la voiture soient disponibles, car le tableau de bord était neuf...

Bonjour, À mon avis, les différences sont minimes et ne justifient peut-être pas un changement si l'original fonctionne correctement. En résumé, j'ai remarqué que les graphismes des avertissements "freinage" et "objet détecté" sont légèrement différents. Les graphiques du niveau de carburant...

I also have the new cruise control stalk, I've had it for over a year and it has always worked fine. It only stopped working after I changed the Cirocco, it detects that I press the "mem" button twice but does not take the new speed. I think the pinout of the Cirocco connector must have changed...

Nac is the Wave4hd.

Yes, to set the new speed we click 2 times fast on the mem key. The thing here is that it´s not working when i use the new Cirocco. If i put the old cirocco on the car, the system works as intended, replacing with the new Cirocco, the system does not work again (the speed setting).

Bonjour à tous, Je viens à nouveau demander votre aide pour essayer de résoudre un problème étrange que j'ai avec mon Peugeot 3008. J'ai récemment acheté un nouveau panneau de bord Cirocco du 3008 restylé, car j'avais lu dans une revue que le panneau avait été "mis à jour" et offrait de...

Do tou have Focal sound system? There is a TSB for that.