Contenu récent par FelixdeVuist

I do not know. SORRY

Because all my messages have been deleted, again here the wiring for the new 308 digital speedo. Following connections, for cars with original ESP and Dynamic Mode Button. From old white connector in Dash to new speedo: Can H pin 1 to 10 Can L pin 2 to 12 Esp Button pin 3 to 17 Dynamic Mode...

Why have all my messages been deleted?

I appreciate your help @marcins. And of cause for all other who help too.

Did a cable bridge for the 120 ohms resistor. It looks like it is coding, shows the green beam in the tool, but does not change telecoding.

I can confirm, on pin 3 and 8 of obd parameter reading works. Coding not. Set therefore sketch to 500kbps.

Tested with arduino Uno SMD and shield v2 from seed Studio, cut off p1, did not work. Changed pin 9 to 10 did not work. Today tested it with elegoo uno r3 an these: ZkeeShop 3 STUKS MCP2515 CAN bus module TJA1050 ontvanger SPI compatibel met Arduino 51 ARM MCU Development Board: Amazon.nl...

Bravo Vlud!!! What a great Job!!!!!!!

Hello, At first I want to apologize not to write in french. I could use Google translate but I think writing in english would be better for understanding. I found this topic after my research on the www. So far as I tried to get access to the nac, I fortunately could get access. There a...