Contenu récent par FrankZZ

for a 5008 P87 the part number is 9816244180 Translated French: the wiring harness part number for a 5008 P87 is 9816244180

Peugeot 5008 (P87) 2019 If we activate the BSG trailer module in BSI, does that also activate the trailer stability program automatically? Or do we need to activate another component in the esp as well? French translated : Si nous activons le module de remorque BSG dans le BSI, cela...

7f317f appears to be an error code. I cannot find it in the arduino sketch Readme, though

I receive 7F317F after sending 3101DFC702 The car is a 5008 from 2019 with 1.6 Petrol (180HP) EAT8 Send: >6A8:688 Recv: OK Send: 1003 Recv: 500300C80014 Send: 3101DFC702 Recv: 7F317F

I was hoping that you (or someone else) know the zone we can use with the arduino?

Hi, I'd like to know how to remove the back trim of the front seats, see the black part of the seat in the attached picture. Has anyone managed to remove this, can you share how you did it?

How did you turn off start stop in ecu?

Maybe this is related? https://www.forum-peugeot.com/Forum/threads/tuto-t%C3%A9l%C3%A9codage-et-calibration-dun-nac-rcc-cirocco-cmb_num-sans-diagbox-via-arduino.121767/post-2770411

On my NAC Wave2 when I press phone piano button I return to the screen that was open in android auto. However when I press the phone button on the steering wheel it goes to the phone screen of android auto like you describe

On wave2: Once android auto is connected and you go to airco settings, I found that if you press the phone piano button it goes back to android auto directly. That saves you 1 touch press

I have a Peugeot 5008 from 2019 using NAC Wave2. Adaptive Cruise Control is fitted from the factory and is working well. I am trying to change to minimum speed threshold for activating ACC from 30km/h to 0km/h. The car has a 1.6 petrol engine with automatic gearbox EAT8. However, this is the...

I found it: https://www.forum-peugeot.com/Forum/threads/tuto-t%C3%A9l%C3%A9codage-et-calibration-dun-nac-rcc-cirocco-cmb_num-sans-diagbox-via-arduino.121767/post-2739080

Thank you very much, I will try this. Where did you find the description of the parameters? I could only find the zones list of bsi/nac in github. Parameter description is very valuable I am also curious if I can disable start/stop in bsi with zone 23BB "Start stop presence and type"

@Jlozde Sorry to reply to an old post, I'm trying to use "trunk from remote" by coding zone 2354 to 04, as is stated in your file "trunk from remote.txt" , coding succeeded. Also when I read zone 2354 it shows parameter is set to 04. I see the car does not turn on the lights anymore when...