Contenu récent par mark102

Hi, does anyone know how to permanently turn off the speed limit warning sound in the new C5 Aircross? It turns on every time I turn on the ignition. New car, new challenges :)

can you share your USB ( arduino ) ?

Engine ECU -.....

Seat belts must be buckled in. Tire pressure OK. In NAC - vehicle settings\safety\Active safety brake is ON ?

compare - these are mine

take a screenshot of the ESB by Diagbox image and help in drive in BSI

Hello Is it possible to change or reset the zone in the EPROM in BSI ? When try changing zones (e.g. DB76O shows up.7F2E31-Configuration Write - Request out of range

https://www.forum-peugeot.com/Forum/threads/tuto-t%C3%A9l%C3%A9codage-et-calibration-dun-nac-rcc-cirocco-cmb_num-sans-diagbox-via-arduino.121767/page-140#post-2724161 You program with the ignition on but the engine off. I programmed in parallel with DG7

The ESP is from the factory, and I have an active Safety Brake. However, the "car close" warning is displayed in yellow - not red It doesn't work - I know because a couple of times I had to brake myself at the last moment I need to upload the factory settings - maybe I changed something myself

only ALERT IN CVM3 Diagbox show AUTOMATIC BRAKING IN CASE OF COLLISION RISK. IN esp the same. Probably coding in BSI?

no, if the ACC is switched off, the car does not brake automatically. Only a red warning is displayed

I checked and I have CVM3. on the camera I have the number 9842997780 but the Diagbox shows 9842725080. My car doesn't brake on its own. it only displays a warning. I think I have poor software in the CVM, or there's something else I don't know about. I think ALBIN has discovered the possibility...

yes I know, but which one? :) the numbers are the same

The original DG PSA service does not recognize my CVM - it tells the operator to choose cvm2 or cvm3. On the Russian forum I found that mine is cvm3 but some poor version of flash.