Contenu récent par marop

Hello! I have Peugeot 408 plug in and I have some problems with Focal. For example audio is shutting down after 2 minute listenig when car is off, like on the movie below. In the second exmple Focal doesnt start with all spekers when i open the car with kayless system. but when i youse button...

In my case, this system works. I replaced the analog speedometer with a matrix display for a digital icockpit. Features such as lane assist or traffic sign recognition worked before and now work and display on the digital icockpit. only the high beam assistant works but it doesn't display the...

How to enable automatic high beam headlights in digital cockpit in 308. I have missing icon from the photo below.

Just do what the diagbox displays, it's easy.

I had the same problem in my rcc a2. you need to configure the camera in diagbox while in the parking lot next to the parking lines

Maybe enybody knows how to eneble smart beams light on 308 Visteon?

Digital cluster (cmb_num) like cirocco. I'm talking about coding to make this control appear

How can i enable this info/control lamp on visteon in 308 t9? System works but without this control lamp.

In my 308 from 2018 I installed a visteon. After that, smart beams do not work for me, is there a way to solve this problem or a configuration that supports it?

Hello. Sorry if this question has already been asked here. Can the problem of the SOURCE/MODE button be solved also by replacing COM2008 with a newer one? e.g. from a car with a digital cluster. However, is the fault with BSI and the only way is arduino?

Hello, using this tutorial and arduino I replaced my RCC with NAC wave2. I have a color display between the speedometer and the tachometer, but the navigation information does not work. Is it the fault of NAC or BSI calibration, or maybe this little color display doesn't support it. It's a 308...

Problem has been solved. it was necessary to calibrate the camera 180 in the diagbox. no token is needed for this.

I did not configure it. He left the factory with these settings. The 2127 zone looks like this: 2127=01049420000000000000000000000600000000000000000005010000000000000000030F0400000000000000

I am using can shiled v2.0. I did not insert a external resistor

When I added a cable for GND, it finally started uploading, but it has already stopped at 3/100. During the next upload, it stopped at 1/100. I thought, according to the information I found, that after October 2017 there was wave 3. How do you know that this is wave 2? There is an inscription...