Contenu récent par ygorigor

This tools is only for NAC/RCC. It's not working with IVI

You are trying to change zone 2101 in BSI, but this zone is from Gearbox. To access Gearbox use 6A9:689 and key 4854

Hi Here you can find some info. It's for 3008, but you can grab some ideas from there. You can use translation from German language. https://www.mittns.de/thread/1311-3008-ii-visiopark-2-nachr%C3%BCsten/?pageNo=1

So you used a parking spot to fix the camera?

You did a calibration from Diagbox?

Sorry, but I can't help you. I don't know what's wrong with your hardware.

Hi From logs I can see that there are some troubles with coding DAE and BSI. It returns the errors codes 7F3E03 ECU Connection lost | No resistor ? CAN-BUS wires bad ? 7F2E22 Failed Configuration Write It seems that is something wrong with your Sketch, it losing connection when it try...

Hi, Put here log from YAT, it should be in C:\3008\YAT projects\

File from this post https://www.forum-peugeot.com/Forum/threads/tuto-t%C3%A9l%C3%A9codage-et-calibration-dun-nac-rcc-cirocco-cmb_num -sans-diagbox-via-arduino.121767/post-2764425

Use the file that I already attached on this forum. If you not sure about what ECU's your car has, read the stored data from each ECU and put it here.

G5

Yes, you can. ESP not need to change. Park assist works without it.

Hi I can try, but if you have AAS_UDS_G6, then I can't help with it because I don't know how to code it.

I didn't save it. Sorry

Maybe yes, maybe no. I can't tell you, it depends what type of ECUs the car has. If ECUs are the same as 3008 then you can use it.