Contenu récent par Miguel Angel

OKAY. But I changed the smeg+ for nac, cirocco from 2014 for cirocco from 2017 and bsm z04 for z05. The only thing left for me would be to change bsi2010 to bsi2010_ev...too expensive. I will investigate to see if it is possible to put an arduino on the can bus and have it send me the data...

Fantastic. Is there something to activate lka or lda in c4 picasso from 2014. I have installed cvm and artiv camera and both work. but I can't get it to show me the lane departure warning lines in the cirocco

I have mounted a windshield dab antenna and I have activated the dab option in nac (wave 2) with the Vlud App. Now it does tune to dab stations, but the volume is lower than the normal antenna. Are there any other settings I haven't seen?

hello. sorry for my late response. I had the bsm Z04-01 9807091880 mounted on the c4 grand picasso ii and I changed it for the bsm Z05-01 9807091980. I repeat, my car is a C4 Picasso from 2014. I hope it helps you

What should I activate so that the time between vehicles appears? Que dois-je activer pour que le temps entre les véhicules apparaisse ? Thanks, merci

Hi. I change the bsm to Z05 and the artiv ecu is working. My car is a c4 picasso ii

@VLud Do you know which is the zone for the time between vehicles to be displayed in the memory of the regulator in the nac?

@VLud Do you know which are the zones of the esp90? pm

Hi @VLud . I hope you can help me because I am lost. I want to put the adaptive cruise control and I bought the radar 9810093180. Remember that my car is a C4 GP MK2. I have mounted it in the car and diagbox does not recognize it. It also does not communicate directly with your arduino...

@slhylcnn @Ringelberg @cmlkrc Have you got something? I have the same problem, I changed the smeg to nac. I put the cvm camera and it changes the lights automatically, I told the bsi that I have the speed respect radar, but I have no communication. I have read the canbus in dump mode and...

try "> 764:664" without quotes And remove the blue jumper. I also use that module, but I changed the crystal oscillator to 16MHz

Hi. Someone who has the CVM multifunctional camera can send me their config file (.nac) I need to see the addresses 2101 and 2109. I am trying to add the camera on my C4 Picasso and I cannot configure the automatic lighting of high beams, I can't get it exit menu at nac. @VLud, any way to...

I update. After putting the cirocco on and updating the km with the bsi to 136000, I had to remove it again and test at home; But when I put it as indicated in the previous post, it marks the same km as before synchronizing with the bsi, how is it possible? Therefore, I notice that what you...

@Ringelberg @James78, I also have the calibration 9692618180 and the cirocco attenuates very little, almost negligible, but something does attenuate. Surely as Ringelberg says, it is something from the calibration file, or some reading address that can be configured by arduino, since there are...