Contenu récent par Piotr

Hello everybody, Has someone implemented a chiptuning in a car? If yes, please share your opinions.

@janfi67 _ many thanks for your reply! When you have connected diagbox during drive FAP burnt completally up to 0 or not. I just ask as my FAP didnt burn completally when i had connected my FAP application on my phone?

Hello everybody, Could you please give me an answer to my question? In a manual book there is written the FAP starts burning when you drive min. 60km/h. What happen if the FAP starts burning then after a while you drive less then 60 km/h? FAP stops burning and starts again when the speed is...

Thanks you very much for your answer. 100400 km. I can' attache the photo but there is written " heating of nox sensor". On the Polish forum i received the answer that the error is due to FAP application I used on my mobile phone. Next week I am pluging on the diagbox and check the errors.

Hello everybody, Yesterday I pluged in my intetface elm 327. I used first time application "fap". Application found one error p2202. No errors on the car screen, no check engine icon. Do you think the problem is with Nox sensor or application generated this error?

Hi Guys, Today I applied a lot of lithium grease and noise still appears. Did you disassembly some parts to have a better access? I used the mirror to see a back of pedal but it is not easy.

Thanks Petroman, I have no any greasy and I will buy it in spray. Thanks gentleman again!

Hi Pierh, Thanks for your reply! I tried to apply WD40 but the noise still appears, I will do like you advise I hope the noise disappears. Regards from Poland!

Hello my friends from France! I don't understand your language and maybe the solution there is on this page that's why I would like to explain my problem in english. I have 308 T9 1.6 BlueHdi and when I push a little bit my clutch pedal I can hear some noise, as I good understood some grease...