Hi guys! After upgrading from a NAC Wave 2 to a NAC Wave 4, i'm facing some issues.
Today I spent some time trying to figure out why the NAC is assuming there are obstacles in front and behind my vehicle, even if I'm in a open field and there is nothing around my car.
The point is: every time I engage the R gear, the Visiopark shows the zoom view and the virtual top view shows red alerts like if there are obstacles close to both bumpers.
I tried to restore the original config file, change the vehicle and compared the W2 and W4 backups but couldn't identify different parameters.
The BSI parameters are correctly set as if I reinstall the W2, the issue go away.
There are no errors on AAS or any BSI related module.
Anybody can think about something I'm missing or had similar issue?
Attached pictures and my W4 config file.
AAS_1 picture was shot while I was parked with any obstacles close to the car.
AAS_2 picture was shot immediately after AAS_1, but I switched the gear lever from R to N.
AAS_3 picture shows the 2 right sensors working properly (the front right yellow and rear right white alerts).
AAS_4 picture show the 2 center front and 2 center rear sensors not working properly.
Thanks.
SOLVED.
The issue was caused by W4 specific parameter on 2133 tab.