i need help replacing a wave 1 with a wave 3 on a Peugeot expert from a friend.
i used
@VLud commands below to the camera because after the w3 install, the camera was with reversed image. After the comands, the image position is fine but the colors remain switched. I think its because pal/ntsc camera. I also didnt use custom calibration as stated by vlud because every calibration i try apart from pro ace or expert, gives me invalid cal file.
apart from the camera i have other two problems. One is the rear sensor for unlocking the door with the foot. i calibrated the wave 3 with pro ace calibration file and switched the brand to Peugeot. The option is present on the NAC menu but the sensor isnt working.
The second one is the parking sensors sound its almost silent.
below the config file present on the nac wave 1
https://easyupload.io/5zn0wv
Parameter change in zone 012A
Calibration_Fct_VP1_HW (
00 = NEW VP1)
Code:
>764:664
2E012A00
1103
Wait for the reboot
Reinstallation of the initial parameter in zone 012A
Calibration_Fct_VP1_HW (
01 = OLD VP1)
Code:
>764:664
2E012A01
1103
Wait for the reboot, 212A zone modification is taken into account and the view changes